Couldn't load pickup availability
Bobcat 7 Pin CAN to CAT ABC Series 8 Pin Only (4 Outputs).
Works with ASV/TEREX also, by moving one pin (H TO G).
Buy this adapter if you have a Bobcat e/w a 7 pin CAN connector and you would like to operate 8 pin 12 volt solenoid operated attachments from old 2015 and prior CAT ABC Series and ASV/Terex only. These attachments are rare so make sure that is exactly what you have. If not, you probably need our SG-CAN60-14 pin output adapter.
Outputs Include:
Disclaimer:
This is not a Bobcat® product. This product is not endorsed by Bobcat®. We are in no way attempting to make you think this is a Bobcat® product. This product is optically isolated from the controls of your machine and can in no way damage your machine or controls. It is perfectly safe to use and will not damage a thing. If a dealer is attempting to tell you that your warranty will be voided if you use this product or that it will damage your machine, please call and report it to us. Skid Steer Genius is a specialty controls company. Our goal is to make anything you buy for your machine work on any machine. Others design and build in such a way as to stop you from doing this.
Bobcat®, the Bobcat logo and the colors of the Bobcat machine are registered trademarks of Bobcat Company in the United States and various other countries.Bobcat Company is a subsidiary of Doosan Infracore Bobcat Holdings Co., Ltd., a wholly owned subsidiary of Doosan Infracore Co., Ltd.
All rights reserved.
CAN60 INTROUCTION VIDEO
It can work with ASV/Terex by moving one pin: move pin H to G.
No. The Bobcat 2020+ Versahandler 923 does not have an ACD controller and is not compatible with this model.
This adapter lets a Bobcat machine with a 7-pin CAN connector run older Caterpillar A/B/C Series 8-pin solenoid attachments (and certain ASV/Terex 8-pin attachments). It provides 4 outputs for 12-volt solenoid control.
No. This adapter is for CAT A/B/C Series 8-pin only. CAT D-Series uses a different setup—if you do not have CAT ABC 8-pin, you likely need the SG-CAN60 (14-pin output adapter) instead.
This model provides 4 outputs for controlling 12-volt solenoids from your Bobcat controls.
A1/A2 (Pins C/D) can be configured for momentary or latching (one or both may latch). C1/C2 (Pins B/H) are momentary only. Ground (A & E) is constant.
Due to fuse and circuit limitations, any combination of 2 outputs can work at the same time. This adapter ships with outputs set to momentary by default.
Yes. Installation takes about one minute and is 100% plug-and-play. It is designed for boom-mount use so you can move it between attachments.
It is made for Bobcat machines that have the 7-pin CAN connector. It works with Pilot Control, Hand/Foot Control, Toolcat, Versahandler, and imported Bobcat machines (note: some machines may still have limitations based on available controls/buttons).
It is intended only for CAT A, B, or C Series 8-pin attachments (typically 2015 and prior) and ASV/Terex 8-pin attachments. These attachments are less common—verify you truly have the CAT ABC 8-pin (or ASV/Terex 8-pin) before ordering.
If you plan on moving pins often, note that single-use tools may not last long. A commercial-duty 8-pin connector tool is recommended for frequent pin changes.
No. This is not a Bobcat® product and it is not endorsed by Bobcat®. It is designed to be optically isolated and safe for your machine when used correctly.
Thanks for subscribing!
This email has been registered!
