Couldn't load pickup availability
Running a John Deere attachment with the plastic 3-pin plug on a Bobcat loader with a 7-pin CAN port? This kit was built for exactly that.
You’ll receive a compact 2-output CAN controller for Bobcat machines plus a dedicated adapter that mates directly to the John Deere 3-pin attachment connector. We also include extra pigtails so you can wire additional 1–2 solenoid attachments without starting from scratch.
This solution connects to your Bobcat® 7-pin CAN port and lets you control up to two 12-volt solenoids straight from your machine’s paddle controls (works on skid steers and also Toolcat® / Versahandler® platforms that use the ACD controller).
Built-in comfort upgrade: we engineered a smart latch/momentary behavior so you don’t have to hold a button all day. Each paddle gives you both styles of control:
Installation is fast and truly plug-and-play (about a minute). Use it as a reusable “plug-mount” controller across any attachment that needs one or two solenoid outputs.
What’s included:
Important compatibility note: Bobcat Versahandler 923 (2020+) is not compatible because it does not use an ACD controller.
Disclaimer: This is not a Bobcat® product and is not endorsed by Bobcat®. The product is optically isolated from machine controls and is designed to operate safely without harming the machine or control systems. Bobcat®, the Bobcat logo, and associated marks are trademarks of their respective owners. All rights reserved.
This kit is designed for Bobcat loaders equipped with a 7-pin CAN controller that need to operate John Deere attachments using a plastic 3-pin connector.
The controller can operate up to two 12-volt solenoids.
It works with Bobcat skid steer loaders, Toolcat machines, and Versahandler machines that use a 7-pin CAN connector.
This kit supports John Deere attachments that use a plastic 3-pin connector and require up to two solenoid outputs.
Yes, the controller features a latching circuit that allows continuous operation without holding the paddle, as well as momentary operation depending on paddle position.
The installation is fully plug-and-play and typically takes about one minute to complete.
Yes, the plug-mount design allows it to be reused on any compatible attachment with one or two solenoids.
The kit includes a two-output CAN bus controller, a John Deere 3-pin adapter, two Deutsch receptacles with pigtails, installation instructions, and factory support.
No, this is not an official Bobcat product and is not endorsed by Bobcat.
No, the Bobcat Versahandler 923 is not compatible because it does not use an ACD controller.
Thanks for subscribing!
This email has been registered!
