Couldn't load pickup availability
Mac Swing Steer 8-Pin to Bobcat 14-Pin Adapter Harness: This adapter is designed specifically for Mac Swing Steer machines equipped with an 8-pin female connector. It converts the machine’s output into the standard Bobcat 14-pin male format, allowing compatibility with a wide range of aftermarket attachments.
Expanded Attachment Compatibility: This harness enables operation of low-flow attachments requiring up to four control functions. It is an ideal solution for users who want to run commonly available aftermarket attachments using a Mac machine platform.
Output Configuration: Due to the design of Mac machines, only four control pins are active. This adapter also includes ground and keyed 12-volt power connections to support proper operation of compatible attachments.
Flow and Performance Note: Mac Swing Steer machines are typically rated around 19 GPM at 2900 PSI. For best performance, this adapter should be used with low-flow or cylinder-operated attachments only.
Pin Adjustment Flexibility: If your attachment requires pin adjustments, this product includes single-use pin tools to assist with basic changes. For frequent or advanced repinning, professional-grade tools are recommended.
This adapter plugs into a Mac Swing Steer 8-pin female connector and converts the outputs to the older Bobcat 14-pin male format so you can run many low-flow aftermarket attachments.
This adapter is made specifically for a Mac Swing Steer machine with an 8-pin female connector.
It provides an old-style Bobcat 14-pin male output format for compatible attachments.
This adapter is designed to support attachments needing up to four controls.
Only four control pins are installed because Mac machines are equipped with only four controls from the factory.
Yes. In addition to the four control pins, the adapter also includes ground and keyed 12-volt pins.
This adapter is best suited for low-flow attachments or cylinder-operated attachments that can work effectively with the machine’s available hydraulic output.
The machine is rated at 19 GPM at 2900 psi, so higher-demand attachments may not perform effectively on this setup.
Yes. The product includes free single-use tools to help with pin changes if your attachment needs to be reconfigured.
No. Based on the machine’s flow rating, this adapter is intended mainly for low-flow or cylinder-operated attachments rather than high-flow attachment applications.
Thanks for subscribing!
This email has been registered!
