- Choosing a selection results in a full page refresh.
Closeout Offer – Limited Quantity Available: This unit is part of a discontinued controller series designed exclusively for 8-pin attachments. Due to surplus inventory being rediscovered, these units are now available at a significantly reduced price while supplies last.
7-Pin CAN to 8-Pin Adapter (4 Outputs): This adapter allows skid steers equipped with a 7-pin CAN connection to operate older 8-pin, 12-volt solenoid-controlled attachments commonly used on earlier CAT ABC Series machines.
Compatible with Multiple Machines: In addition to Bobcat systems, this adapter can also be used with ASV and Terex machines by repositioning a single pin (H to G), providing added flexibility for operators working across different equipment brands.
Important Compatibility Information: This adapter is specifically intended for older 8-pin attachment systems. These attachment types are less common, so it is essential to verify your setup before purchasing. If your attachment requires a different configuration, a 14-pin output adapter may be more suitable.
Output Configuration:
This adapter is a cost-effective solution for maintaining compatibility with legacy attachments without upgrading your entire system. With limited stock available, it is an excellent opportunity to secure a reliable adapter at a discounted price.
This controller is designed to allow Bobcat machines with a 7-pin CAN connector to operate specific 8-pin attachments that use 12-volt solenoids.
No. It is intended only for older CAT ABC Series and ASV/Terex 8-pin attachments, typically from 2015 and earlier. These attachments are uncommon, so compatibility should be confirmed before purchasing.
Yes, it can work with ASV and Terex machines, but it may require moving one pin from position H to G for proper operation.
This controller provides four outputs, allowing control of multiple solenoid functions depending on the attachment setup.
The outputs are configured for momentary operation only, meaning functions are active only while the control input is engaged.
A1 and A2 correspond to pins C and D and are designed for momentary control of attachment functions.
C1 and C2 correspond to pins B and H and also provide momentary control for additional attachment functions.
The ground connections on pins A and E are set up as ground-only, providing the necessary return path for the electrical system.
No. This controller is specifically for 8-pin attachment setups. If you are using a 14-pin attachment, a different adapter designed for that configuration would be required.
No. This is a close-out item from an older model that has already been replaced by a newer version, so availability is limited to remaining stock.
Sign up for exclusive updates, new arrivals & insider only discounts
Thanks for subscribing!
This email has been registered!