Couldn't load pickup availability
18" Jumper Cable (CB-1000 & CB-4000 Only)
This 18-inch jumper cable is built to make attachment wiring simple when you’re using a CB-1000 or CB-4000 Genius Controller. One end features a 2-pin Deutsch plug that connects directly to your controller, while the other end has bare, stripped wires so you can splice into the attachment wiring you need.
Just plug the Deutsch end into your Genius Controller, then splice the stripped-wire end into your attachment harness. You’ll need to have a harness in place (or build one) to complete the install.
Important: Use one cable with the CB-1000 and CB-4000 only.
Disclaimer:
This is not a Bobcat® product and is not endorsed by Bobcat®. We are in no way attempting to make you think this is a Bobcat® product. This product is optically isolated from the controls of your machine and can in no way damage your machine or controls. It is perfectly safe to use and will not damage a thing. If a dealer is attempting to tell you that your warranty will be voided if you use this product or that it will damage your machine, please call and report it to us. Skid Steer Genius is a specialty controls company. Our goal is to make anything you buy for your machine work on any machine. Others design and build in such a way as to stop you from doing this.
Bobcat®, the Bobcat logo and the colors of the Bobcat machine are registered trademarks of Bobcat Company in the United States and various other countries.Bobcat Company is a subsidiary of Doosan Infracore Bobcat Holdings Co., Ltd., a wholly owned subsidiary of Doosan Infracore Co., Ltd.
All rights reserved.
This 18" jumper cable is designed to connect a Genius Controller to an attachment when you need bare, stripped wire leads for splicing. One end plugs into the controller, and the other end allows you to splice directly into your attachment wiring.
This cable is intended for use with the CB-1000 and CB-4000 controllers only.
One end has a 2-pin Deutsch plug that connects to the Genius Controller. The opposite end has bare stripped wires for splicing into an attachment harness.
No. This is a splice-in jumper cable. Installation requires wiring work to connect the stripped wires to your attachment.
Yes. You must have a harness in place on the attachment side in order to properly splice and use this cable.
No. When used as intended with compatible Genius Controllers, the cable is optically isolated from machine controls and is safe to use.
No. This is not a Bobcat® product and is not endorsed by Bobcat®. All Bobcat® trademarks belong to their respective owners.
Thanks for subscribing!
This email has been registered!
