Couldn't load pickup availability
This adapter is specially designed to plug into any Bobcat® 7 Pin connector and allow the operator to run up to 2 x 12 volt solenoids directly from the left and right paddle controls of your Bobcat®. Works on Bobcat® skid steer loaders as well as Toolcat® and Versahandler® machines.
What is amazing about this is that we have taken our engineering to another level. This controller features a unique latching circuit so that you do not have to hold your thumb down for 8 hours for continuous operation.
It works like this: Plug in our controller and your switching paddles will be transformed. On your left paddle, touch the bottom part and it works momentarily. Touch the top and it latches. Touch either again and it releases. Same for the right paddle.
Toolcat and Versahandler owners: Plug it in the same way as a skid steer and use the console switches (Older Models) or handle controls to operate attachments.
Takes about 1 minute to install. 100% plug-and-play…
What is included:
This is not just a plug-in adapter. It includes a microprocessor + driver circuit that enables functionality.
Bobcat Versahandler 923 - DOES NOT WORK WITH THIS MODEL BECAUSE IT DOES NOT HAVE AN ACD CONTROLLER.
Disclaimer:
This is not a Bobcat® product…
Bobcat®, the Bobcat logo… trademarks statement…
Older Style 2000 controller that operates the same as the new one
This adapter plugs into the Bobcat 7-pin connector and lets you run up to two 12-volt solenoids directly from the left and right paddle controls. It converts the machine’s CANBus signals into simple on/off power for your attachment.
It works with Bobcat skid steer loaders, Toolcat machines, and Versahandler models that use the standard 7-pin attachment control system with an ACD controller. It is not universal for other brands or for machines that do not use the Bobcat 7-pin CANBus layout.
You can control two separate 12-volt solenoids or functions. One is assigned to the left paddle and one to the right paddle, giving you independent control for each output on your attachment.
The lower part of each paddle works as a momentary switch, while the upper part acts as a latch. Press down for momentary operation, press up to latch the output on, and press again (up or down) to release. This lets you keep functions like sprayers or lights on without holding the paddle all day.
Installation is plug and play. You simply plug the adapter into the 7-pin connector and connect the DT06 2-pin leads to the solenoids on your attachment. No cutting, splicing, or reprogramming of the machine is required for compatible models.
The adapter uses two Deutsch DT06 2-pin receptacles with pigtails so you can easily connect to your attachment solenoids or wire them into an existing harness using standard Deutsch components.
Yes. It includes an LED indicator that shows when the adapter has power, is communicating with the machine, and when the paddles are activating the outputs. This makes troubleshooting and setup much easier.
It is more than a plug. Inside is a microprocessor and driver circuitry that interprets the Bobcat CANBus commands and safely switches 12-volt power to the solenoids. That’s why it can provide advanced features like latching control while remaining plug and play.
Yes. Some machines, such as certain Versahandler models without an ACD controller, are not compatible. Always verify that your machine uses the standard Bobcat 7-pin CANBus control system before ordering.
The adapter is optically isolated from the machine’s controls and is designed not to backfeed or alter the OEM system. It does not modify the factory wiring and is intended to be a safe, reversible add-on for controlling compatible attachments.
Thanks for subscribing!
This email has been registered!
